SATO s84ex - ESC+TU Printing Tag Data

304
16.6 RFID Command
ESC+TU Printing tag data
16.2
ESC+TU
Hexadecimal
code
ESC
TU
Parameter
<1B>16
<54>16<55>16
a ,bbcccddd n~n
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
Reads data from a specified area and specified address of RFID tag and develops to specified direction to make it possible to
print on labels.
[Format]
<TU>a,bbcccdddn~n
●Parameter
a = To use this functionality or not
1 : Read data and start using
0 : Cancel use
bb = Block number
01 : EPC area
02 : TID area
03 : USER area
ccc = Start address of memory. Range: 000 to 999 (in decimal)
ddd = End address of memory. Range: 000 to 999 (in decimal)
n = Specify ID. Specify any string within 4 to 16 characters to be used for assigning data.
(All parameters should be in the ASCII format)
[Notes]
1. The amount of information per one address is 2 bytes (4 characters) in case of Gen2. An RFID tag error occurs if you specify
an address that exceeds tag capacity.
2. The upper limit of the read data is 32 characters, even there is enough capacity in the read targeted area.
3. It is not possible to acquire CRC/PC in the EPC area with this command. Please specify 02H in the below figure "Memory
map of Gen2 standard RFID chip" as the base reference: 0, when specifying EPC area address.
4. 1 address is one word (= 16 bits), and it is equal to 4 characters.
Memory map of Gen2 RFID chip
Bank
00H
01H
02H
03H
0
4
H
0
5
H
0
6
H
0
7
H
0
8
H
0
9
H
0
A
H
0
B
H
.
.
.
.
.
EPC area
CRC
PC
EPC
TID area
TID
USER area
USER
Printing tag data
Address