SATO s84ex - Basic Specifications (Wireless LAN)

396
6.2 Basic Specifications (wireless LAN)
Interface
(Wireless LAN adapter)
Wireless LAN board
Protocol
Status 3, Status 4, Status 5
Refer to 2 Communication Protocol for details.
LED
LED
Color
Motion Specification
LEVEL
Green
Field intensity
LED lights: strong (more than Signal Level 3)
LED blinks: medium (more than Signal Level 2, less
than Signal Level 3)
LED off: weak (less than Signal Level 2)
*LED lights always when at the Ad Hoc mode.
LINK
Green
Link:
LED blinks: not connected to an access point
LED lights: connected to an access point
STATUS
Orange
Status
LED blinks: for a certain time when received packets
MODE
Green
Wireless LAN Mode
LED blinks: Ad Hoc mode
LED lights: Infrastructure mode
*It's impossible to confirm the LED because this will be installed inside the printer.
*The field intensity will be displayed on the printer LCD. Refer to the ”Operator Manual”
for more details.
Setting of communication
conditions
The following communication setting can be done in the communication setting mode
of the printer.
Setting Items
Setting range
Protocol
Status 3 Return
Status 4 (cycle response mode)
Status 4 (ENQ response mode)
Printer Status 5 Return
IP Address
0.0.0.0 - 255.255.255.255
Default Value: 192.168.1.1
Subnet Mask
0.0.0.0 - 255.255.255.255
Default Value: 255.255.255.0
Gateway Address
0.0.0.0 - 255.255.255.255
Default Value: 192.168.1.2
IP Address Settings
DISABLE (manual setting) (default value)
ENABLE
Communication mode
Ad Hoc mode
Infrastructure mode
SSID
SSID
Default: SATO_PRINTER
Channel
1 - 13
Default Value: 6