SATO s84ex - LAN, Wireless LAN; Basic Specifications (LAN)

394
6 LAN, wireless LAN
6.1 Basic Specifications (LAN)
Interface
Protocol
Status 3, Status 4, Status 5
Refer to
2 Communication Protocol
for details.
Connector
Connector type RJ45
Cable type 10BASE-T, 100BASE-TX (category 5 or upper)
Cable length shorter than 100 (m)
Link/Status LED
LED lights when LINK with the Ethernet is established or the printer received packet.
Communication setting
The following communication setting can be done on the communication
setting mode of the printer.
LED
Color
Motion Specification
LED1
Green
LED lights for a certain time when received packets
(10 msec)
LED2
Yellow
LED goes off when the printer detected the connection
to 10BASE-T
LED lights when the printer detected the connection to
100BASE-TX
LED lights when a cable is not connected
Common setting
Setting Items
Setting range
Protocol Status 3 return
Status 4 return (cycle response mode)
Status 4 return (ENQ response mode)
Printer Status 5 Return
IPv4 setting
Setting Items
Setting range
IP Address 0.0.0.0 - 255.255.255.255
Default Value: 192.168.1.1
Subnet Mask 0.0.0.0 - 255.255.255.255
Default Value: 255.255.255.0
Gateway Address 0.0.0.0 - 255.255.255.255
Default Value: 0.0.0.0
IP Address Settings DISABLE (manual setting)
ENABLE
Default value: DISABLE (manual setting)
LED2
LED1