232
Valid range and
term of
command
When the power switch is OFF
The set parameter is maintained.
The set parameter is in effect until a new specification is made.
The set parameter is in effect until a new specification is made.
[Function]
Register job modification character string.
[Format]
<#J>,a,b,c
●Parameter
a [ID number] = Valid range : 0 or 1 to 9 (default: 0 delete all job modification pairs)
b [Search character string] = Valid range : 00 to FF (default: delete designated modification pairs)
c [Replace character string] = Valid range : 00 to FF (default: no replace character string)
[Coding Example]
<A>
<#J>,1,1B584D,1B584C
<Z>
[Notes]
1. Specify the search and replace character string in 2 digits ASCII in HEX.
2. When 0 is specified for an ID number, all job modification pairs are deleted.
3. When the search character string parameter is omitted, the specified job modification pair is deleted.
4. When replace character string parameter is omitted, replace is not done and only search character string is deleted from the
input data.
[Remarks]
1. The search or replace character string for job modification is saved in the EEPROM, and it is maintained until it is deleted or
job modification function is disabled.
2. The search or replace character string can be specified up to 100 characters, 9 pairs in total. For example, a pair of
search/replace character string has 50 characters each, only one pair can be used.
3. The character string is searched in the order of from #J1 to #J9. When higher priority search character string is the subset of
lower priority search character string, the lower priority search character string is ignored.
4. When the HEX dump mode is used for the printing of the received data, print output depends on the job modification setting.
5. The job modification function is disabled automatically during the test print mode.
Job Modification
To Next Page
Loading...
