139
[Note 1]
1. When Kanji is specified in the <DN>, specify the size of number of Kanji character x2.
2. When auto setting is on and <DN> specification, 80H~9FH and E0H~FFH is treated as Kanji mode and binary cannot be
specified.
[Coding Example 1] Error correction level: 7%, size of a side: 05
data setting mode: manual setting, combine mode: normal
<A>
<V>100<H>200
<2D31>,L,05,0,0
<DS>1,012345
<Q>2
<Z>
[Note 2]
1. The code will not be printed when a parameter other than above is specified or number of print data does not match.
2. The data specification command in the data part varies according to the setting of the parameter part or specified data
contents.
[Coding Example 2] Error correction level: 7%, Size of one side of cell: 04
Mixed specification of Manual setup (Data setup mode)
In Manual setup, you can proceed specifying data in specified input mode (Numeric, Alphanumeric, Kanji,
Binary).
<A>
<V>100<H>200
<2D31>,L,04,0,0
<DS>3,サトー
<DN>0010,0123456789
<DS>1,123
<Q>1
<Z>
[Note 3]
Please specify the data part after the parameter part. Also, specify the data part after the data part continuously. When this fails,
printing may not be correct.
[Coding Example 3] Error correction level: 7%, size of a side: 05
data setting mode: manual setting, combine mode: normal, printed with version 5
<A>
<V>100<H>200
<2D31>,L,05,0,0
<QV>5
<DS>1,012345
<DN>0004,6789
<Q>1
<Z>
[Note 4]
1. Specify the <QV> command in between <2Dxx> and <DN>/<DS>.
2. When the parameter error occurs, it will be treated as no specification.
3. The parameter error will not occur in the range of 00~40. (Please specify the value in the range supported in the model)
Setting range (MODEL1): 00 to 14
4. The command error occurs and the QR code will not be printed when data exceeded the size limit of the specified version
data size.
To Next Page
Loading...
