24
[Notes]
1. When the print start position is outside of the printable area, printing will not be performed due to command error.
2. Specify the line width of the horizontal direction for more than 0.166mm according to the list below.
3. In case of the ruled line, when the line width of the vertical line is widened, the right side against the feed direction is widened.
When the line width of the horizontal line is widened, the below against the feed direction is widened.
4. In case of frame line, the line will be widened for inside.
5. Please specify 8 digits bit pattern for the ruled line. (1 digit = 4 bits, 1 bit = 1 dot)
6. When the ruled pattern is less than 8 digits, data are generated repeatedly from the specified data until it becomes 8 digits
data.
Example) When ruled line pattern "FOC" is specified, ruled line pattern "FOCFOCFO" is generated.
7. When a pattern is specified, the image is generated in 4 bytes of the drawing area. When the print base reference point is not
in 4 bytes, the image is misaligned for 1 dot because the data are generated from in the middle of the pattern.
[Valid Range]
[S84-ex]
[S86-ex]
To Next Page
Loading...
