322
*2 Occurrence of buffer-over depends on the interface.
[o: Interface that buffer-over occurs, x: Interface that buffer-over doesn't occur ]
(4) ENQ respond delay time setting
You can use delay timer function to delay returning the printer status to the host by setting [ENQ respond delay time]
in the service mode. Refer to the “Operator Manual” for more setting details.
*
*
*1 Time period of "+α" varies according to the interface or the behavior of the application in the host.
2) Cancel request command
This command enables to cancel print jobs and to clear the entire contents of the receive buffer.
The printer returns the printer status of after completion of the current process.
*When the cancel request command has sent, wait more than 500 msec before sending the next data.
*This command shall not be used during sending printer data and other data.
(1) Command CAN (HEX 18H)
(2) Return status list
3) Print Command
The printer start
s printing by re
ceiving the print command (STX
<A> ~<Z> ETX).
The printer returns the printer status after receiving process is completed.
(1) Return status list (Printer status)
An example of the job ID number command <ID>
Refer to the Job ID number command <ID>.
<ID>01
<V>100<H>100<P>2<L>0202<XM>ABC
<Q>1
Create status information
Send buffer
STX xxA000000････ ETX
ENQresponse delay time
+ α
*1
To Next Page
Loading...
