SATO s84ex - Page 350

342
STX (HEX 02H)
ETX (HEX 03H)
(Total: 3 bytes)
13) SNMP agent information request
This command returns the SNMP agent information of the printer.
(1) Command SOH(01H) +LX
(2) Return status format
[STX] + sysContact + sysName + sysLocation + [ETX]
STX
sysContact
sysName
sysLocation
ETX
(3) Return status list
No.
Item
Description
Number of bytes
1
sysContact
Return sysContact that is set.
256
2
sysName
Return sysName that is set.
256
3
sysLocation
Return sysLocation that is set.
256
If each item is less than 256 bytes, the remaining are filled with 0x00, so the size is fixed to 256 bytes. It is possible to
display because it is the contact at trouble, however, it is according to SNMP rules.
In case of LAN, it is divided to multiple packets. In case of Status 4, packet size will be indicated at the beginning 4 bytes
of each packet. There is no rules regarding the number of division. Make sure to take the packet including ETX.
Example) when divided into 5 packets
770 bytes + 4 bytes x 5 packets = total 790 bytes
14) SNMP function status request
This command returns the SNMP function ON/OFF state of the printer.
(1) Command SOH(01H) +LY
(2) Return status format
[STX] + SNMP ON/OFF state + [ETX]
STX
SNMP ON/OFF
ETX
(3) Return status list
No.
Item
Description
Number of bytes
1
SNMP ON/OFF
0: OFF
1: ON
1
STX (HEX 02H)
ETX (HEX 03H)
(Total: 770 bytes)