74
[Notes]
1. Register external character of W16xH16 dots to the internal memory or user registration memory.
2. Re-entry to the registered area is allowed.
3. Refer to the data registration procedure below.
4. Registered contents in the memory of the printer will be deleted by turning off the printer. Re-register again for the next
operation.
5. When Kanji data is replaced (GB18030 ⇔ BIG5 ⇔ KSX1001), re-register again after deleting the external character
registration.
External character file: [16 ×16]
D1 and D2 respectively consist of [00000001] and [10000000]. To register the above external character, consider D1 data as
<01>16 and D2 data as <80>
16
.
In the same manner, D3 as <03>
16
, D4 as <00>
16
, D5 as <3F>
16
, and D6 as <FC>
16
, so that the specification of external
character registered data will be <018003003FFC·····>16 and up to D32.
[Remarks]
1. When it is registered in the user registration memory, the data is maintained even the printer power is off.
2. It is not possible to use the internal memory specification and user registration memory specification at the same time.
3. Please specify the slot of the registered memory.
However, it will be registered in the internal memory when <CC> command is not yet sent after the printer power on.
To Next Page
Loading...
