SATO SG112-ex - Hex Dump Mode

4 Operation and Configuration
125
SG112-ex Operator Manual
4.2.9 Hex Dump Mode
The hex dump mode allows you to print the contents of the receive buffer in a hexadecimal format to
allow the data stream to be examined for errors and troubleshooting.
The flowchart shows the sequence of the setting screens for the hex dump mode. The table describes
each setting screen in detail.
SELECT DUMP DATA
Select the data for printing the hex dump.
• RECEIVE DATA: Print the hex dump of the received data.
• RECEIVE BUFFER: Print the hex dump of the received print data (one
item).
• INTERNAL DATA: Print the setting values of the internal buffer.
Note
RECEIVE BUFFER cannot be selected if there is no received data.
ENTER button
CANCEL button
HEX dump print
Return to HEX DUMP MODE menu.
Select RECEIVE BUFFER + ENTER button/
INTERNAL DATA + ENTER button
ENTER button
HEX dump print
Select RECEIVE DATA + ENTER button
For internal buffer Hex dump
printing and internal buffer data
printing, the screen automatically
changes to normal mode after
issuing the media.
LINE button
LINE button
After issuing the media
Data reception
icon is displayed when
RECEIVE BUFFER is selected.
icon is displayed when
INTERNAL DATA is selected.
* Press the , , or button to select an item or set the value
accordingly. The active arrow icons are shown on the screen.
* Pressing the FUNCTION button on each screen will revert to the
HEX DUMP MODE menu.