SATO SG112-ex - Interface

8 Appendix
223
SG112-ex Operator Manual
8.8.3 Interface
Media (Use consumables from our specified suppliers.)
Size
Continuous Mode
Pitch
(With Liner)
30 to 420 mm (1.2” to 16.5”)
33 to 423 mm (1.3” to 16.6”)
Width
(With Liner)
128 to 297 mm (5.0” to 11.7”)
131 to 300 mm (5.2” to 11.8”)
Tear-off Mode
Pitch
(With Liner)
40 to 420 mm (1.6” to 16.5”)
43 to 423 mm (1.7” to 16.6”)
Width
(With Liner)
128 to 297 mm (5.0” to 11.7”)
131 to 300 mm (5.2” to 11.8”)
Cutter Mode
Pitch
(With Liner)
40 to 420 mm (1.6” to 16.5”)
43 to 423 mm (1.7” to 16.6”)
Width
(With Liner)
128 to 297 mm (5.0” to 11.7”)
131 to 300 mm (5.2” to 11.8”)
Media Tray
Pitch
(With Liner)
40 to 117 mm (1.6” to 16.5”)
43 to 120 mm (1.7” to 16.6”)
Width
(With Liner)
128 to 297 mm (5.0” to 11.7”)
131 to 300 mm (5.2” to 11.8”)
Maximum stack height: 5 mm (0.2”) (approx. 40 sheets, 0.12 mm (0.008”) thick/sheet)
Note
When DISABLE is selected in PITCH SENSOR, the minimum label size varies depending on the print
speed. Refer to Section 8.7.17 When Sensor is Disabled for details.
Thickness (Label and
liner)
Cut: 0.08 to 0.21 mm (0.003” to 0.008”)
Feed: 0.08 to 0.27 mm (0.003” to 0.01”), use media with thickness of
0.12 mm (0.005”) or greater for auto feed function.
Interface
Standard USB Interface (Type B)
LAN Interface
RS-232C Interface
IEEE1284 Interface
External Signal Interface (EXT)
SD card slot
USB Host (Type A)