SATO SG112-ex - No Pulse Input in Motion 3 Cutter Mode (Head Check Enabled)

8 Appendix
215
SG112-ex Operator Manual
8.7.13 No Pulse Input in Motion 3 Cutter Mode (Head Check Enabled)
(1) Operation
(2) Timing chart
0HGLDIHHGGLUHFWLRQ
*1 When the next print data is received after the first label is printed, the product prints the next data and cut the first one
when it reaches the cut position.
*2 If there is no data received after the print operation, and when the eject cut standby time is expired, eject cut is performed.
(Note)
࣭The base position using the Gap sensor is shown above.
Cut Pitch sensor (Gap)
ձ ղ ճ
After printing the 1st label
Before Print
Print & Cut
After printing the 2nd label
Head
ղ ճ մ ձ
ճ մ
ձ
ղ ճ մ
ղ
Receive the next data after the first print *1
Eject-cut
ճ մ յ
ղ
յ
When the eject-cut standby time is expired *2
Backfeed
ճ մ յ
Label feed
Cut
PRIN
Ext. signal
PREND(TYPE1)
PREND(TYPE2)
PREND(TYPE3)
PREND(TYPE4)
Head check
Operation
Power ON
Print 1st Print 2nd
Eject-cut
Eject-cut standby time