SATO SG112-ex - When a Warning Message Appears

7 Troubleshooting
177
SG112-ex Operator Manual
a
7.2 When a Warning Message Appears
When a warning message is shown on the screen, the product continues issuing media.
The warning message, its cause and the countermeasures are as follows:
Warning
No. Message LED/Buzzer Cause Countermeasure
01
Ribbon near end
ONLINE: Lights
green.
STATUS: Off
LABEL: Off
RIBBON: Flashes
red.
No beep.
To clear the error:
Open and close the
print head.
The remaining amount of
ribbon is not enough.
Replace the ribbon.
Refer to Section 3.2
Loading the Ribbon for
details.
02
Receive buffer
nearly full
ONLINE: Lights
green.
STATUS: Flashes
green.
LABEL: Off
RIBBON: Off
No beep.
Available space for
receive buffer is low.
Do not send data from the
host until the analysis of
received data is
completed.
03
Command error
ONLINE: Lights
green.
STATUS: Off
LABEL: Off
RIBBON: Off
One short beep.
To clear the error:
The icon will be
cleared by receiving
the next item or
canceling the job.
Command error has been
detected.
Check the print data.