SATO SG112-ex - With Pulse Input in Tear-Off Mode (Head Check Disabled)

8 Appendix
209
SG112-ex Operator Manual
8.7.7 With Pulse Input in Tear-off Mode (Head Check Disabled)
(1) Operation
(2) Timing chart
0HGLDIHHGGLUHFWLRQ
Pitch sensor (Gap)
ձ ղ ճ
Stand-by
ղ ճ մ
Head
(Note)
࣭The base position using the Gap sensor is shown above.
ձ
Input PRIN signal
ղ ճ մ ձ
Manual cut
Feed to the manual cut
position after printing
the 1st label.
Backfeed to the Print
base position
Label feed
Cut
PRIN
Ext. signal
PREND(TYPE1)
PREND(TYPE2)
PREND(TYPE3)
PREND(TYPE4)
Head check
Operation
Power ON
Print 1st label Print 2nd label
The amount of time before PRIN signal is received by the product.
*1㸬Retain PRIN until PREND is output.
20ms
1 1
20ms
500ms 500ms