SATO SG112-ex - External Signal Interface (EXT)

8 Appendix
236
SG112-ex Operator Manual
8.9.5 External Signal Interface (EXT)
This interface is designed to connect the product with other peripherals.
Basic Specifications
Connector Amphenol 14 pins, female
Signal Levels High-level: +4.2 to +5.0 V
Low-level: +0.0 to +0.7 V
Connector Pin Specifications
Pin No. I/O Description
1 Output Paper End:
Outputs a low signal when the paper end is detected.
2 - GND: Reference Signal Ground
3 Output Ribbon End:
Outputs a low signal when the ribbon end is detected.
4 Output Machine Error:
Outputs a low signal when an error such as the head open error is
detected.
5 Input Print start signal (PRIN):
Prints one media when a low signal is detected.
6 Output Print Done/Print end signal (PREND):
Outputs a low signal when the media print is completed.
7 Input Reprint signal (PRIN2):
Prints the previously printed content again when a low signal is
detected.
8 Input External power supply: 5 V
9 Output Online/Offline:
Outputs a low signal when the product is in offline mode.
10 Output Ribbon Near End:
Outputs a high signal when the ribbon near end is detected.
11 - -
12 - +24 V ± 10%
13 - Vcc +5 V
14 - -
17
814