SATO SG112-ex - Test Print Mode

4 Operation and Configuration
130
SG112-ex Operator Manual
4.2.11 Test Print Mode
The flowchart shows the sequence of the setting screens for the test print mode. The table describes
each setting screen in detail.
Note
• When EXTERNAL SIGNAL in the ADVANCED MODE menu is set to ENABLE, the product is unable to
perform the test print correctly.
Make sure that the EXTERNAL SIGNAL is set to DISABLE before performing test print.
Test print
ENTER button
CANCEL button
When the
above
TEST
PRINT
MODE Is
set as
FONT or
MEMORY.
Press FEED button
+
Switch Power to On “ I ”
When the above TEST
PRINT MODE Is set as
FACTORY.
When the above TEST PRINT
MODE Is set as
CONFIGURATION,
BARCODE or HEAD CHECK.
ENTER buttonENTER button
ENTER button
CANCEL button
or
button
* Press the , , or button to
select an item or set the value
accordingly. The active arrow icons
are shown on the screen.
* Pressing the FUNCTION button on
each screen will revert to the TEST
PRINT MODE menu.
FP
3,7&+326,7,21
(17(5!35,17
PP
2))6(7326,7,21
(17(5!35,17
PP
'$5.1(66
(17(5!35,17

or
button
or button