SATO SG112-ex - Download and Upload Specification

8 Appendix
191
SG112-ex Operator Manual
8.1.5 Advanced Mode
Setting Item Initial Value
Default
(Setting)
Factory
(ALL)
DARKNESS RANGE A Yes Yes
PRINTER TYPE AUTO SETTING ENABLE Yes Yes
PRINTER TYPE TEAR OFF/
CUTTER (When cutter unit is installed)
Yes Yes
EJECT CUT MOTION DISABLE Yes Yes
BACKFEED MOTION BEFORE Yes Yes
PRINT METHOD TRANSFER Yes Yes
PITCH SENSOR ENABLE (When CONTINUOUS or
CUTTER is selected)
Yes Yes
SENSOR TYPE GAP Yes Yes
CHECK MEDIA SIZE DISABLE Yes Yes
COMMAND ERROR DISABLE Yes Yes
HEAD CHECK DISABLE Yes Yes
HEAD CHECK NORMAL (When HEAD CHECK is
enabled)
Yes Yes
HEAD CHECK MODE ALL (When HEAD CHECK is enabled) Yes Yes
HEAD CHECK PAGE NO. 000001 (When CHECK PAGE is
selected)
Yes Yes
EXTERNAL SIGNAL DISABLE Yes Yes
EXTERNAL SIGNAL TYPE4 Yes Yes
EXTERNAL REPRINT DISABLE Yes Yes
SET CALENDAR NO - -
CALENDAR 11/01/01 00:00 No Yes
CALENDAR INPUT 11/01/01 00:00 No Yes
CALENDAR CHECK ENABLE Yes Yes
AUTO ONLINE YES Yes Yes
AUTO ONLINE FEED NO Yes Yes
FEED ON ERROR YES Yes Yes
SELECT LANGUAGE ENGLISH Yes Yes
EURO CODE D5 - Yes
PROTOCOL CODE STANDARD Yes Yes
LCD POWER SAVING 00 MIN Yes Yes
ERROR INDICATION NONE Yes Yes