SATO SG112-ex - Hex Dump Mode; Test Print Mode; Default Setting Mode

8 Appendix
192
SG112-ex Operator Manual
8.1.6 Hex Dump Mode
8.1.7 Test Print Mode
8.1.8 Default Setting Mode
Setting Item Initial Value
Default
(Setting)
Factory
(ALL)
SELECT DUMP DATA RECEIVE DATA - -
Setting Item Initial Value
Default
(Setting)
Factory
(ALL)
TEST PRINT MODE CONFIGURATION - -
TEST PRINT SIZE 26 cm
(When CONFIGURATION, BARCODE,
HEAD CHECK is selected)
--
LARGE
(When FACTORY is selected)
--
PITCH POSITION +0.00mm No No
OFFSET POSITION +0.00mm No No
DARKNESS 50 Yes No
Setting Item Initial Value
Default
(Setting)
Factory
(ALL)
DEFAULT MODE PRINTER SETTING - -
DEFAULT PRINTER SETTING NO - -
DEFAULT ALT.PROTOCOL NO - -