SATO SG112-ex - Upload Mode

4 Operation and Configuration
140
SG112-ex Operator Manual
4.2.14 Upload Mode
The upload feature allows the operator to upload data (firmware, font/logo, TrueType font, configuration,
status5 log) from the product and write it to an SD card or USB memory. When uploading is complete,
the LCD screen will return to the original screen after three seconds. If an error occurs, an error message
will show and the reason will be identified.
CAUTION
Be sure to perform a virus check on the USB memory or SD card before connecting it to the product. SATO
Corporation shall not be held responsible for any product malfunctions caused by a virus spread via USB
memory or SD card.
ENTER button
Upload
completed?
Yes
No
Reading the data
Writing the data
Finished receivng the uploaded data
Finished writing the uploaded data
ENTER button
ENTER button
Press button
+
Switch Power to On “ I ”
3 short beeps when the
upload is completed
・If the item selected on the UPLOAD SELECT screen does not have
data to be uploaded, nothing will be uploaded.
・Selecting ALL will upload all the items on the UPLOAD SELECT
screen.
・Screen messages are displayed in English regardless of the setting
value on the SELECT LANGUAGE screen.