SATO SG112-ex - LAN Interface

8 Appendix
230
SG112-ex Operator Manual
8.9.2 LAN Interface
Basic Specifications (When IPv4 is selected)
Connector RJ-45 Receptacle
Power Supply Powered from the product
Protocol Status3
Status4 (Cyclic response mode)
Status4 (ENQ response mode)
Status5
IP Address 0.0.0.0 - 255.255.255.255
Initial: 192.168.1.1
Subnet Mask 0.0.0.0 - 255.255.255.255
Initial: 255.255.255.0
Gateway Address 0.0.0.0 - 255.255.255.255
Initial: 0.0.0.0
Basic Specifications (When IPv6 is selected)
Connector RJ-45 Receptacle
Power Supply Powered from the product
Protocol Status3
Status4 (Cyclic response mode)
Status4 (ENQ response mode)
Status5
IP Address 0000:0000:0000:0000:0000:0000:0000:0000 -
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF
Initial: 0000:0000:0000:0000:0000:0000:0000:0000
Prefix 0 -128
Initial: 64
Default Router 0000:0000:0000:0000:0000:0000:0000:0000 -
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF
Initial: 0000:0000:0000:0000:0000:0000:0000:0000