SATO SG112-ex - Information Mode

4 Operation and Configuration
127
SG112-ex Operator Manual
4.2.10 Information Mode
The flowchart shows the sequence of the setting screens for the information mode. The table describes
each setting screen in detail.
Shows as “---.---.---.---” if an
IP address is not acquired
from the DHCP setting.
* Press the , , or button to select an item or set the value
accordingly. The active arrow icons are shown on the screen.
* Pressing the FUNCTION button on each screen will revert to the
INFORMATION MODE menu.
ENTER button
CANCEL button
CANCEL button
ENTER button
CANCEL button
ENTER button
CANCEL button
ENTER button
CANCEL button
ENTER button
CANCEL button
ENTER button
CANCEL button
ENTER button
6*H[
9HU;;;;;;;;
/$1,3Y$''5(66



/$1,3$''5(66

/$1,3Y5287(5



ENTER button