SATO SG112-ex - IEEE 1284 Interface Connection; RS-232 C Interface Connection

2 Installing the Product
31
SG112-ex Operator Manual
2.3.5 IEEE 1284 Interface Connection
1 Make sure that the product is powered
off.
2 Connect the IEEE1284-compliant cable
to the IEEE1284 connector of the
product.
• Use a cable that is compatible with the
standard of the interface board as stated in
Section 8.9.4 IEEE1284 Interface. Check the
orientation of the connector before you make
the connection.
3 Configure the interface settings.
Refer to Section 2.3.7 Interface Settings for
more details on interface settings.
Note
• If the product is powered on without installing the printer driver, Windows’ Plug & Play runs. When using the
printer driver, do not power on the product while the cable is connected, until instructed in the procedure for
installing the printer driver.
• IEEE1284-compliant: compatible mode, ECP mode, and nibble mode are supported.
• Some computers may not support ECP mode.
• ECP mode is configured in the BIOS settings of the computer. Some computers may use the software tools
for Windows.
• Some computer models may not perform ECP operations even if they are set to ECP mode. Contact the
computer manufacturer.
• Printing using the USB parallel conversion cable is not guaranteed. Also, no support for the connection
procedure is provided.
2.3.6 RS-232C Interface Connection
1 Make sure that the product is powered
off.
2 Connect the RS-232C cable to the RS-
232C connector of the product.
• Use a cable that is compatible with the
standard of the interface board as stated in
Section 8.9.3 RS-232C Interface. Check the
orientation of the connector before you make
the connection.
3 Configure the interface settings.
Refer to Section 2.3.7 Interface Settings for
more details on interface settings.
IEEE1284
RS-232C