SATO SG112-ex - Adjustment Mode

4 Operation and Configuration
64
SG112-ex Operator Manual
4.2.3 Adjustment Mode
The product has a quick access to the adjustment mode for setting the print position, stop position and
print darkness. These adjustments are in conjunction with the configuration adjustments performed in
the user mode menu.
1 When the product is in offline mode, press the button to enter the adjustment mode.
PITCH POSITION shows on the screen.
2 Press the / buttons to set the desired value and press the ENTER button to save
the setting and proceed to the next adjustment screen.
PITCH POSITION
Offset the print start position in the vertical direction.
Set the offset value with '+' to move the print position opposite the feed
direction and value with '-' to move the print position in the feed direction.
The setting value is adjustable by 0.25 mm (0.01”) regardless of the print
resolution.
The setting range is from -3.75 mm (-0.15”) to +3.75 mm (+0.15”).
OFFSET POSITON
Correct the offset position.
Offset position refers to the stop or cut position of each media after
printing.
Set the offset value with '+' to move the stop position opposite the feed
direction and value with '-' to move the stop position in the feed direction.
The setting value is adjustable by 0.25 mm (0.01”) regardless of the print
resolution.
The setting range is from -3.75 mm (-0.15”) to +3.75 mm (+0.15”).
Press the FUNCTION or
CANCEL button
button
ENTER
button
* Press the or button to set the value.
ENTER
button
ENTER
button