SATO SG112-ex - 8 Appendix; List of Initial Values; Normal Mode; User Mode

187
SG112-ex Operator Manual
8.1 List of Initial Values
The initial value refers to the setting value of the product when it was shipped from the factory.
If you reset the product in default setting mode, the setting values of the product will change back to the
factory default values. The tables below show the initial value of each setting item and the type of reset
that changes the value back to the initial value.
CAUTION
It is generally not necessary to perform the initialization. Doing so will remove all the customer settings.
8.1.1 Normal Mode
8.1.2 User Mode
8
Appendix
Setting Item Initial Value
Default
(Setting)
Factory
(ALL)
ADJUSTMENT MODE
PITCH POSITION Varied No No
OFFSET POSITION Varied No No
DARKNESS 50 No No
Buzzer Volume 2 Yes Yes
LCD Brightness Midrange Yes Yes
Setting Item Initial Value
Default
(Setting)
Factory
(ALL)
PRINT SPEED 04 IPS Yes Yes
PRINT DARKNESS 05 Yes Yes
PITCH OFFSET +00 mm Yes Yes
PRINT OFFSET V:+0000 H:+0000 Yes Yes
ZERO SLASH YES Yes Yes
CHARACTER CODE JIS Yes Yes
KANJI FONTS GOTHIC Yes Yes
CHARACTER PITCH PROPORTIONAL Yes Yes
NOTIFICATION FUNCTION SETTING NO - -
NOTICE FUNCTION CLEAN PRINTER Yes Yes
NOTICE FUNCTION DISABLE Yes Yes