SATO SG112-ex - Changing Backfeed Distance

5 Adjusting the Product
152
SG112-ex Operator Manual
5.4.6 Changing Backfeed Distance
When you are using cutter mode, adjust the backfeed distance in consideration of the cut position
(OFFSET POSITION) and the print position (PITCH POSITION) to prevent the media being shifted away
(fall off) from the platen roller after cutting motion.
The following examples show the effect of print position and cut position on backfeed distance.
Example 1
Example 2
Cut position Base reference point for printing
36.2 mm
(1.4”)
Platen roller
Edit Buffer
For PITCH POSITION= -3.00mm (-0.12”) / OFFSET POSITION= 0mm
*1. The original backfeed distance before adjustment is 39.2 mm (1.5”), however it is adjusted to 36.2 mm (1.4”) in this case to prevent the
media from falling off the platen roller area.
*2. To resolve the misalignment of print due to decreased backfeed length, adjust print starting line to +3mm (+0.12”) from the original stop
position.
36.2 mm (1.4”)
Distance between the cut
position and print position
Original stop position (media will fall off).
*2
*1
$%&
Cut position
Base reference point for printing
Edit Buffer
+3.0 mm
(+0.12”)
Platen roller
*1
*2
Distance between the cut
position and print position
For PITCH POSITION= 0mm / OFFSET POSITION= +3.00mm (+0.12”)
Original stop position (media will fall off).
36.2 mm
(1.4”)
36.2 mm (1.4”)
*1. The original backfeed distance before adjustment is 39.2 mm (1.5”), however it is adjusted to 36.2 mm (1.4”) in this case to prevent the
media from falling off the platen roller area.
*2. To resolve the misalignment of print due to decreased backfeed length, adjust print starting line to +3mm (+0.12”) from the original stop
position.