SATO SG112-ex - Adjusting the Print Quality

5 Adjusting the Product
153
SG112-ex Operator Manual
Comparison between single cut and multiple cut
Example 1
For PITCH POSITION= -3.00mm (-0.12”) / OFFSET POSITION= 0mm
a) Single media cut
a) Multiple media cut


Cut position Base reference point for printing
Platen roller
3.0mm
(0.12”)
Edit BufferEdit Buffer
+3.0 mm
(+0.12”)
Base reference
point for printing
Base reference
point for printing
(*1)
(*2)
Distance between the cut
position and print position
*1. The original backfeed distance before adjustment is 39.2 mm (1.5”), however it is adjusted to 36.2 mm (1.4”) in this case to prevent the
media from falling off the platen roller area.
*2. To resolve the misalignment of print due to decreased backfeed length, adjust print starting line to +3mm (+0.12”) from the original stop
position.
Original stop position (media will fall off).
36.2 mm (1.4”)
36.2 mm
(1.4”)


Cut position Base reference point for printing
Platen roller
3.0mm
(0.12”)
Edit BufferEdit Buffer
+3.0 mm
(+0.12”)
Base reference
point for printing
Base reference
point for printing
Distance between the cut
position and print position
*1. The original backfeed distance before adjustment is 39.2 mm (1.5”), however it is adjusted to 36.2 mm (1.4”) in this case to prevent the
media from falling off the platen roller area.
*2. To resolve the misalignment of print due to decreased backfeed length, adjust print starting line to +3mm (+0.12”) from the original stop
position.
Original stop position (media will fall off).
36.2 mm (1.4”)
36.2 mm
(1.4”)
Non-printable area
(*1)
(*2)