SATO SG112-ex - No Backfeed;Pulse Input in Cutter Mode

8 Appendix
211
SG112-ex Operator Manual
8.7.9 No Backfeed/Pulse Input in Cutter Mode
(1) Operation
(2) Timing chart
0HGLDIHHGGLUHFWLRQ
ձ
Cut Pitch sensor (Gap)
ձ ղ ճ
Print 1st label
Stand-by
ղ ճ մ
Cut
Print 2
n
d
label
Print head
*1 Take note that there are some non-printable areas, as no backfeed is performed.
(Note)
࣭The base position using the Gap sensor is shown above.
ձ
*1 Non-printable area
ղ ճ մ
ճ մ յ ղ
ճ մ յ ղ ձ
ձ
Cut
Label feed
Cut
PRIN
Ext. signal
PREND(TYPE1)
PREND(TYPE2)
PREND(TYPE3)
PREND(TYPE4)
Head check
Operation
Power ON
Print 1st label Print 2nd label