SATO SG112-ex - Adjusting the Print Position

5 Adjusting the Product
147
SG112-ex Operator Manual
5.4.2 Adjusting the Print Position
Print position is adjustable within the range of +3.75 mm to -3.75 mm (+0.15” to -0.15”) in the
Adjustment Mode. The shift experienced by the media, ribbon or print layout can be offset with the
adjustment of the pitch position.
Note
The above base reference point (print position) is the stop position when the media sensor type is set to Gap.
Adjust the print position using the following procedure:
1 Make sure that the product is in offline mode.
2 Press the button to enter the adjustment
mode.
PITCH POSITION shows on the screen.
Adjustment Location Adjustment Range
Adjustment Mode: Pitch Position +3.75 mm to -3.75 mm (+0.15” to -0.15”)
-3.75 mm (-0.15”) ~ +3.75 mm (+0.15”)
Media feed direction
Base reference
point for printing
(Print head)
Adjustment for
“+” value
No
adjustment
Adjustment for
“-” value
Gap sensor
117.1 mm (46.1”)