SATO SG112-ex - Interface Mode

4 Operation and Configuration
74
SG112-ex Operator Manual
4.2.6 Interface Mode
The flowchart shows the sequence of the setting screens for the interface mode. The table describes
each setting screen in detail.
Setting contents vary depending on the interface.
Proceed to .
If you selected USB, proceed to
If you selected LAN, proceed to
If you selected RS-232C, proceed to
If you selected IEEE1284, proceed to
I-F
I-A
I-C
I-B
I-D
* Press the , , or button to select an item or set the value
accordingly. The active arrow icons are shown on the screen.
* Pressing the FUNCTION button on each screen will revert to the
INTERFACE MODE menu.
ENTER button
CANCEL
button
ENTER button
CANCEL
button
Select “NO” +
ENTER button
CANCEL
button
Select “YES” +
ENTER button
Select “SUB PORT” + ENTER button
CANCEL
button
CANCEL
button
Select “DATA PORT”
+ ENTER button
ENTER button
CANCEL
button
Select “USB”/ “LAN”/
“RS-232C”/ “IEEE1284”
+ ENTER button
CANCEL
button
Select “NONE” +
ENTER button
ENTER button
CANCEL
button
72&+$1*(
35(66(17(5.(<
726$9(
32:(52))