SATO SG112-ex - With Pulse Input in Motion 2 Cutter Mode

8 Appendix
218
SG112-ex Operator Manual
8.7.16 With Pulse Input in Motion 2 Cutter Mode
(1) Operation
(2) Timing chart
0HGLDIHHGGLUHFWLRQ
The amount of time before the product acknowledges PRIN signal.
Cut Pitch sensor (Gap)
ձ ղ ճ
Print 1st label
Standby
Cut
Backfeed
Head
ղ ճ մ ձ
ղ ճ մ ձ
ձ ղ ճ
Input PRIN signal
(Note)
࣭The base position using the Gap sensor is shown above.
Label feed
Cut
PRIN
Ext. signal
PREND(TYPE1)
PREND(TYPE2)
PREND(TYPE3)
PREND(TYPE4)
Operation
Power ON
Print 1st Print 2nd
*1㸬Retain PRIN until PREND is output.
20ms
*1
*1
Backfeed Backfeed
Head check(TYPE1,2)
Head check(TYPE3,4)