SATO SG112-ex - No Backfeed and with Pulse Input in Cutter Mode

8 Appendix
216
SG112-ex Operator Manual
8.7.14 No Backfeed and With Pulse Input in Cutter Mode
(1) Operation
(2) Timing chart
0HGLDIHHGGLUHFWLRQ
Cut Pitch sensor (Gap)
ձ ղ ճ
Print 1st label
Standby
ղ ճ մ
Cut
Head
*1 No backfeed is performed in this mode, thus some area will be left non-printable
(Note)
࣭The base position using the Gap sensor is shown above.
ձ
*1 Non-printable area
ղ ճ մ ձ
Input PRIN signal
Label feed
Cut
PRIN
Ext. signal
PREND(TYPE1)
PREND(TYPE2)
PREND(TYPE3)
PREND(TYPE4)
Head check(TYPE1,2)
Operation
Power ON
Print 1st Print 2nd

The amount of time before the product acknowledges PRIN signal.
*1㸬Retain PRIN until PREND is output.
20ms
*1 *1
Head check (TYPE3,4)