SATO SG112-ex - Adjusting the Media Stop Position for Option

5 Adjusting the Product
148
SG112-ex Operator Manual
3 Change the setting value. Press the
/ buttons to set the desired value.
Set the offset value with ‘+’ to move the print
position opposite the feed direction, and value
with ‘-’ to move the print position in the feed
direction.
The setting value is adjustable by 0.25 mm (0.01”)
regardless of print resolution.
The setting range is from -3.75 mm (-0.15”) to
+3.75 mm (+0.15”).
4 Press the ENTER button to save the
setting and go to the next adjustment
screen.
5.4.3 Adjusting the Media Stop Position for Option
The stop position for options (such as cutter) is adjustable within the range of +3.75 mm to -3.75 mm
(+0.15” to -0.15”) in the Adjustment Mode.
Note
• The above cut position for printing indicates the media stop position when the media sensor type is set to
Gap.
• You can also adjust when the operation mode is specified to Tear-off.
Adjustment Location Adjustment Range
Adjustment Mode: Offset Position +3.75 mm to -3.75 mm (+0.15” to -0.15”)
-3.75 mm (-0.15”) ~ +3.75 mm (+0.15”)
Media feed direction
Cut position
36.2 mm
(14.3”)
Adjustment for
“+” value
No
adjustment
Adjustment for
“-” value
Base reference
point for printing
(Print head)