SATO SG112-ex - Page 151

5 Adjusting the Product
149
SG112-ex Operator Manual
Adjust the stop position using the following procedure:
1 Make sure that the product is in offline mode.
2 Press the button to enter the adjustment
mode.
PITCH POSITION shows on the screen.
3 Press the ENTER button to go to the next
adjustment screen.
OFFSET POSITION shows on the screen.
4 Change the setting value. Press the /
buttons to set the desired value.
Set the offset value with ‘+’ to move the stop
position opposite the feed direction, and value
with ‘-’ to move the stop position in the feed
direction.
The setting value is adjustable by 0.25 mm (0.01”)
regardless of print resolution.
The setting range is from -3.75 mm (-0.15”) to
+3.75 mm (+0.15”).
5 Press the ENTER button to save the
setting and proceed to the next
adjustment screen.