159
SG112-ex Operator Manual
6.1
Cleaning the Product
A dirty print head or platen roller not only affects the print quality but also causes errors. Use a cleaning
kit or cleaning sheet to clean the product regularly.
CAUTION
• Do not power on or off the product, connect or disconnect the power cord while your hands are wet. Doing
so could cause an electric shock.
• Disconnect the power cord from the AC outlet before you begin cleaning.
The print head and its surroundings are hot after printing. Wait until the product cools down.
• Touching the edge of the print head with your bare hand could cause injury.
• Be careful not to touch the cutter blade when cleaning the product.
• Use a cotton swab or cotton cloth from a cleaning kit for cleaning. Do not clean with a hard object. Doing so
could cause damage.
• Before cleaning, remove the media and ribbon.
Note
The cleaning kit and cleaning sheet are optional. Contact your SATO reseller or technical support center to
purchase the options.
6
Maintenance
To Next Page
Loading...
