SATO SG112-ex - Adjusting the Base Reference Point; About the Base Reference Point

5 Adjusting the Product
146
SG112-ex Operator Manual
5.4 Adjusting the Base Reference Point
5.4.1 About the Base Reference Point
The base reference point is the point at which one determines the print position and stop/cut position.
The base reference point differs depending on the operation mode or media sensor you use.
Gap sensor
I-mark sensor
Gap sensor
I-mark sensor
Print
position
Cut
position
Print
position and
cut position
Print
position
Print
position
Feed direction Feed direction
Feed direction Feed direction
Continuous Mode
Cutter Mode
Gap sensor
I-mark sensor
Tear-off Mode
Print
position and
tear-off
position
Print
position
and
tear-off
position
Feed direction Feed direction