SATO SG112-ex - Ribbon and Media

8 Appendix
222
SG112-ex Operator Manual
8.8.2 Ribbon and Media
Print
Print Method Direct thermal and thermal transfer
Print Speed 75, 100, 125, 150 mm/sec (3, 4, 5, 6 inches/sec)
Resolution 305 dpi (12 dots/mm)
Non-printable Area Pitch direction (Excludes liner)
Top: 1.5 mm (0.06”), Bottom: 1.5 mm (0.06”)
Width direction (Excludes liner)
Left: 1.5 mm (0.06”), Right: 1.5 mm (0.06”)
Printable Area Maximum Length 420 mm (16.5”) x Width 266.7 mm (10.5”)
Print Darkness Darkness level: 1 to 10
Sensors
I-mark
(Reflective Type)
Sensitivity: Adjustable
Gap
(Transmissive Type)
Sensitivity: Adjustable
Head Open Fixed
Cutter cover Fixed
Label End Sensor Sensitivity: Adjustable
Ribbon End Sensor Fixed
Ribbon (Use consumables from our specified suppliers.)
Size Width: 145 mm to 273 mm (5.7” to 10.7”)
Length: Maximum 300 m (984.25 ft.)
Wind Direction Face-in
Roll Diameter Maximum 70 mm
Core Diameter 33.6 ±0.4 mm
Media (Use consumables from our specified suppliers.)
Type Fan-fold media
• Maximum stack height: 100 mm (3.9”) from the surface on which the
product rests.
The maximum stack height above may not apply depending on where
the media is set.
Media roll
• Maximum roll diameter: 200 mm (8”)
• Core diameter: 76 mm (3”)
• Use an optional unwinder (UWG112) for this media type.