6 Maintenance
165
SG112-ex Operator Manual
4 Lift up the print head assembly to the
maximum.
CAUTION
• The print head and its surroundings are hot after
printing. Be careful not to touch it, to avoid being
burned.
• Touching the edge of the print head with your bare
hand could cause injury.
5 Remove the media, carbon ribbon and
make the print head visible.
6 Place the cleaning sheet between the
print head and the platen roller .
Note
• The matte side of the cleaning sheet should be
facing upwards (print head).
7 Insert the cleaning sheet from the back
of the front panel and the leading edge
out from the media discharge outlet .
Make sure that there is enough area for you to
pull the cleaning sheeting and area for the
cleaning sheet to cleaning the print head.
8 Close the print head assembly . Press
on both sides as shown by the arrow to
close it tightly until it clicks.
To Next Page
Loading...
