SATO SG112-ex - Page 88

4 Operation and Configuration
86
SG112-ex Operator Manual
PRIVACY KEY
Input SNMP privacy key.
Input more than 8 characters for the authentication name.
Press the
/ buttons to shift the cursor and press the / buttons to
change the value.
Press the ENTER button to save the value and proceed to the next setting
screen.
Note
• When the authentication name is less than 8 characters, there will be
buzzer sounds and it will not move to the next screen.
• Up to 32 alphanumeric characters and symbols (from 20H to 7EH) can
be set.
• Specify “ ” to input a space.
• The setting will be effective only if you power on the product again.
USER MIB WRITE
Enable or disable writing to MIB at authentication access.
• ENABLE: Allows writing to MIB.
• DISABLE: Does not allow writing to MIB.
Note
Writing possible OID are sysContact, sysName, and sysLocation.
TRAP
Set the SNMP trap.
• ENABLE: Allows the SNMP trap.
• DISABLE: Does not allow the SNMP trap.
Note
The setting will be effective only if you power on the product again.