SATO SG112-ex - Page 92

4 Operation and Configuration
90
SG112-ex Operator Manual
USB Setting
PROTOCOL
Set the communication protocol.
• STATUS4: When selected, the product will proceed to the IGNORE
CR/LF screen.
• STATUS5: When selected, the product will proceed to the ITEM NO.
CHECK screen.
ITEM NO. CHECK
Set the item number check function.
• ENABLE: Enable the item number check function.
• DISABLE: Disable the item number check function.
Note
Shows only if PROTOCOL is set to STATUS5.
Shows only when
STATUS5 is selected.
I-A
Proceed to .
I-F
CANCEL button
CANCEL button
CANCEL button
ENTER button
ENTER button
ENTER button
* Press the , , or button to select an item or set the value
accordingly. The active arrow icons are shown on the screen.
* Pressing the FUNCTION button on each screen will revert to the
INTERFACE MODE menu.