EasyManua.ls Logo

Segger J-Link - Page 108

Segger J-Link
480 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
108 CHAPTER 3 J-Link software and documentation package
J-Link / J-Trace (UM08001) ©
2004-2017 SEGGER Microcontroller GmbH & Co. KG
3.3.3.28 SWO DisableTarget
Syntax
SWO DisableTarget <PortMask[0x01-0xFFFFFFFF]>
Description
Disables the output of SWO data on the target (Undoes changes from SWO Enable-
Target) and stops J-Link to capture it.
Example
#Disable captureing SWO from stimulus ports 0 and 1
> monitor SWO DisableTarget 3
< SWO disabled succesfully.
3.3.3.29 SWO EnableTarget
Syntax
SWO EnableTarget <CPUFreq[Hz]> <SWOFreq[Hz]> <PortMask[0x01-0xFFFFFFFF]
<Mode[0]>
Description
Configures the target to be able to output SWO data and starts J-Link to capture it.
CPU and SWO frequency can be 0 for auto-detection.
If CPUFreq is 0, J-Link will measure the current CPU speed.
If SWOFreq is 0, J-Link will use the highest available SWO speed for the selected /
measured CPU speed.
Note: CPUFreq has to be the speed at which the target will be running when
doing SWO.
If the speed is different from the current speed when issuing CPU speed auto-detec-
tion, getting SWO data might fail.
SWOFreq has to be a quotient of the CPU and SWO speeds and their prescalers. To
get available speed, use SWO GetSpeedInfo.
PortMask can be a decimal or hexadecimal Value. Values starting with the Prefix "0x"
are handled hexadecimal.
Example
#Configure SWO for stimulus port 0, measure CPU frequency and calculate SWO frequency
> monitor SWO EnableTarget 0 0 1 0
< SWO enabled succesfully.
#Configure SWO for stimulus ports 0-2, fixed SWO frequency and measure CPU frequency
> monitor SWO EnableTarget 0 1200000 5 0
< SWO enabled succesfully.
#Configure SWO for stimulus ports 0-255, fixed CPU and SWO frequency
> monitor SWO EnableTarget 72000000 6000000 0xFF 0
< SWO enabled succesfully.
3.3.3.30 SWO GetMaxSpeed
Syntax
SWO GetMaxSpeed <CPUFrequency [Hz]>
Description
Prints the maximum SWO speed supported by and matching both, J-Link and the
target CPU frequency.
Example
#Get SWO speed for 72MHz CPU speed
> monitor SWO GetMaxSpeed 72000000
< Maximum supported SWO speed is 6000000 Hz.

Table of Contents

Other manuals for Segger J-Link

Related product manuals