Segger J-Link - Software Overview

70 CHAPTER 3 J-Link software and documentation package
J-Link / J-Trace (UM08001) ©
2004-2017 SEGGER Microcontroller GmbH & Co. KG
3.1 Software overview
The J-Link software and documentation package, which is available for download
from http://www.segger.com/jlink-software.html includes some applications to be
used with J-Link. It also comes with USB-drivers for J-Link and documentations in pdf
format.
Software Description
JLink Commander Command-line tool with basic functionality for target analysis.
J-Link GDB Server
The J-Link GDB Server is a server connecting to the GNU
Debugger (GDB) via TCP/IP. It is required for toolchains using
the GDB protocol to connect to J-Link.
J-Link GDB Server
command line ver-
sion
Command line version of the J-Link GDB Server. Same func-
tionality as the GUI version.
J-Link Remote
Server
Utility which provides the possibility to use J-Link / J-Trace
remotely via TCP/IP.
J-Mem Memory
Viewer
Target memory viewer. Shows the memory content of a run-
ning target and allows editing as well.
J-Flash
a
a. Full-featured J-Link (PLUS, PRO, ULTRA+) or an additional license for J-Link base model required.
Stand-alone flash programming application. For more informa-
tion about J-Flash please refer to J-Flash ARM User’s Guide
(UM08003).
J-Link RTT Viewer
Free-of-charge utility for J-Link. Displays the terminal output
of the target using RTT. Can be used in parallel with a debug-
ger or stand-alone.
J-Link SWO Viewer
Free-of-charge utility for J-Link. Displays the terminal output
of the target using the SWO pin. Can be used in parallel with a
debugger or stand-alone.
J-Link SWO Ana-
lyzer
Command line tool that analyzes SWO RAW output and stores
it into a file.
JTAGLoad
Command line tool that opens an svf file and sends the data in
it via J-Link / J-Trace to the target.
J-Link Configurator
GUI-based configuration tool for J-Link. Allows configuration of
USB identification as well as TCP/IP identification of J-Link. For
more information about the J-Link Configurator, please refer to
J-Link Configurator on page 167.
RDI support
a
Provides Remote Debug Interface (RDI) support. This allows
the user to use J-Link with any RDI-compliant debugger.
Processor specific
tools
Free command-line tools for handling specific processors.
Included are: STR9 Commander and STM32 Unlock.
Table 3.1: J-Link / J-Trace related software