Segger J-Link - Getting Started

To Next Page

To Previous Page

301

11.3 Getting Started

This chapter presents an introduction to J-Flash SPI. It provides an overview of the

included sample projects and describes the menu structure of J-Flash SPI in detail.

11.3.1 Setup

For J-Link setup procedure required in order to work with J-Flash SPI, please refer to

chapter Setup on page 157

11.3.1.1 What is included?

The following table shows the contents of all subdirectories of the J-Link software and

documentation pack with regard to J-Flash SPI:

11.3.2 Using J-Flash SPI for the first time

Start J-Flash SPI from the Windows Start menu. The main window will appear, which

contains a log window at the bottom and the Project window of a default project on

the left. The application log will initially display:

• The version and time of compilation for the application.

• The version and time of compilation for the J-Link DLL.

• The location of the default project.

The Project window contains an overview of the current project settings (initially, a

default project is opened).

Directory Contents

. Contains the J-Flash SPI executable.

.\Doc Contains the J-Flash SPI documentation.

.\Samples\JFlash-

SPI\ProjectFiles

Contains sample projects for J-Flash SPI.

Table 11.1: J-Flash SPI directory structure

Other manuals for Segger J-Link