130 CHAPTER 3 J-Link software and documentation package
J-Link / J-Trace (UM08001) ©
2004-2017 SEGGER Microcontroller GmbH & Co. KG
Start J-Link Remote Server in tunneling mode
Connect to the J-Link / J-Trace via J-Link commander
J-Link Commander can be used to verify a connection to the J-Link can be estab-
lished as follows:
Start J-Link Commander
From within J-Link Commander enter
ip tunnel:<SerialNo>
If the connection was successful it should look like in this screenshot.
To Next Page
Loading...
