Segger J-Link - Page 154

154 CHAPTER 3 J-Link software and documentation package
J-Link / J-Trace (UM08001) ©
2004-2017 SEGGER Microcontroller GmbH & Co. KG
-SetPowerTarget <Mode>
Example
JLinkSTM32.exe -SetPowerTarget 1 // Target power will be set
-SetDeviceFamily
This command allows to specify a device family, so that no user input is required to
start the unlocking process.
Syntax
-SetDeviceFamily <Parameter>
Parameter
There are two different options to specify the device family to be used:
a) Pass the list index from the list which shows all supported familys on start up
b) Pass the defined device name
Example
JLinkSTM32.exe -SetDeviceFamily 6 // Selects STM32L1 series
JLinkSTM32.exe -SetDeviceFamily STM32L1xxxx // Selects STM32L1 series
-Exit
In general, the J-Link STM32 utility waits at the end of the unlock process for any
user input before application closes. This option allows to skip this step, so that the
utility closes automatically.
Syntax
-Exit <Mode>
Example
JLinkSTM32.exe -Exit 1 // J-Link STM32 utility closes automatically
ListIndex Name
1 STM32F0xxxx
2 STM32F1xxxx
3 STM32F2xxxx
4 STM32F3xxxx
5 STM32F4xxxx
6 STM32L1xxxx
Table 3.17: Available Parameter for -SetDeviceFamily