Segger J-Link - Page 227

J-Link / J-Trace (UM08001) © 2004-2017 SEGGER Microcontroller GmbH & Co. KG
227
Syntax
DisableInfoWinFlashDL
5.12.1.11DisableMOEHandling
The J-Link DLL outputs additional information about mode of entry (MOE) in case the
target CPU halted / entered debug mode. Disabled by default.
Syntax
DisableMOEHandling
5.12.1.12DisablePowerSupplyOnClose
This command is used to ensure that the power supply for the target will be disabled
on close.
Syntax
DisablePowerSupplyOnClose
5.12.1.13EnableAutoUpdateFW
This command is used to enable the automatic firmware update if a new firmware is
available.
Syntax
EnableAutoUpdateFW
5.12.1.14EnableEraseAllFlashBanks
Used to enable erasing of other flash banks than the internal, like (Q)SPI flash or CFI
flash.
Syntax
EnableEraseAllFlashBanks
5.12.1.15EnableFlashBPs
This command enables the FlashBP feature.
Syntax
EnableFlashBPs
5.12.1.16EnableFlashDL
This command enables the J-Link ARM FlashDL feature.
Syntax
EnableFlashDL
5.12.1.17EnableInfoWinFlashBPs
This command is used to enable the flash download window for the flash breakpoint
feature. Enabled by default.
Syntax
EnableInfoWinFlashBPs
5.12.1.18EnableInfoWinFlashDL
This command is used to enable the flash download information window for the flash
download feature.