Segger J-Link - Page 233

J-Link / J-Trace (UM08001) © 2004-2017 SEGGER Microcontroller GmbH & Co. KG
233
5.12.1.36SelectTraceSource
This command selects the trace source which shall be used for tracing.
Notes
1. This is only relevant when tracing on a target that supports trace via pins as well as
trace via on-chip trace buffer and a J-Trace (which supports both) is connected to the
PC.
Syntax
Select2TraceSource = <SourceNumber>
Example
SelectTraceSource = 0 // Select ETB
5.12.1.37SetAllowFlashCache
This command is used to enable / disable caching of flash contents. Enabled by
default.
Syntax
SetAllowFlashCache = 0 | 1
Example
SetAllowFlashCache = 1 // Enables flash cache
5.12.1.38 SetAllowSimulation
This command can be used to enable or disable the instruction set simulation. By
default the instruction set simulation is enabled.
Syntax
SetAllowSimulation = 0 | 1
Example
SetAllowSimulation 1 // Enables instruction set simulation
5.12.1.39SetBatchMode
This command is used to tell the J-Link DLL that it is used in batch-mode / automa-
tized mode, so some dialogs etc. will automatically close after a given timeout. Dis-
abled by default.
Syntax
SetBatchMode = 0 | 1
Example
SetBatchMode 1 // Enables batch mode
5.12.1.40SetCFIFlash
This command can be used to set a memory area for CFI compliant flashes.
Trace source number Description
0ETB
1ETM
2MTB