76 CHAPTER 3 J-Link software and documentation package
J-Link / J-Trace (UM08001) ©
2004-2017 SEGGER Microcontroller GmbH & Co. KG
3.2.1.10 flist
On emulators which support file I/O this command shows the directory tree of the
Flasher.
Syntax
flist
3.2.1.11 fread (frd)
On emulators which support file I/O this command reads a specific file. Offset applies
to both destination and source file.
Syntax
fread <EmuFile> <HostFile> [<Offset> [<NumBytes>]]
Example
fread Flasher.dat C:\Project\Flasher.dat
3.2.1.12 fshow
On emulators which support file I/O this command reads and prints a specific file.
Currently, only Flasher models support file I/O.
Syntax
fshow <FileName> [-a] [<Offset> [<NumBytes>]]
Example
fshow Flasher.dat
3.2.1.13 fsize (fsz)
On emulators which support file I/O this command gets the size of a specific file. Cur-
rently, only Flasher models support file I/O.
Syntax
fsize <FileName>]
Example
fsize Flasher.dat
Parameter Meaning
EmuFile File name to read from.
HostFile Destination file on the host.
Offset Specifies the offset in the file, at which data reading is started.
NumBytes Maximum number of bytes to read.
Parameter Meaning
FileName Source file name to read from the Flasher.
a If set, Input will be parsed as text instead of being shown as hex.
Offset Specifies the offset in the file, at which data reading is started.
NumBytes Maximum number of bytes to read.
Parameter Meaning
FileName Source file name to read from the Flasher.
To Next Page
Loading...
