Sencore MRD 3187B - Page 120

MRD 3187B - User Manual
Page 119 (245)
Synchronization Source Setup Type
1. Use the and buttons to move
the cursor to “SSRC Setup:” then
press the button.
2. Use the and buttons select
the desired type of SSRC Setup
(“Auto”, “User”), then press the
button to save the selection.
Synchronization Source Setup
Note: The Synchronization Source is used to further distinguish RTP sources
that use the same IP and port.
Note: This option will only be available if the SSRC SETUP is set to, “User”.
1. Use the and buttons to
move the cursor to “SSRC:” then
press the button.
2. Use the and buttons to
select the column to edit and use
the and buttons to
change the SSRC, then press the
button to save the selection.
Differentiated Services
1. Use the and buttons to
move the cursor to “DiffServ:” then
press the button.
2. Use the and buttons to
select the desired differentiated
services (“Default”, “AF11”, “AF12”,
“AF13”, “AF21”, “AF22”, “AF23”,
“AF31”, “AF32”, “AF33”, “AF41”,
“AF42”, “AF43”, “EF”), then press
the button to save the
selection.
Source Port
1. Use the and buttons to move
the cursor to “Src Port:” then press the
button.
2. Use the and buttons to
select the column to edit and use the
and buttons to change the
port (0 – 65536), then press the
button to save the selection.
IP Packets / MPEG Frame
This setting defines how many IP packets will be transmitted per MPEG frame.
MPEG/IP 1-3 ←→
SSRC:0x00000000
DiffServ:Default
►Src Port:00000
MPEG/IP 1-3
SSRC Setup:User
SSRC:0x00000000
►DiffServ:Default
MPEG/IP 1-3 ←→
RTP
SSRC Setup:User
► SSRC:0x00000000
MPEG/IP 1-3
FEC:Off
RTP
► SSRC Setup:User