MRD 3187B - User Manual
Page 147 (245)
Audio 4 Index
Note: This menu is only available if the unit is equipped with a second decoder in
Configuration 1.
1. Use the and buttons to move
the cursor to “Audio 4 Index:” then
press the button.
2. Use the and buttons to set
the desired audio index (0 – 65535),
then press the button to save the
selection.
Note: Use the previous steps to setup the Priority 2 as well.
No PSI Mode
This mode should only be used if both the PID information and audio/video formats
are known about the stream.
Note: This menu is only available if the “Tune Mode” is set to “No PSI”.
PCR PID
1. Use the and buttons to move
the cursor to “PCR PID :” then press
the button.
2. Use the and buttons to
select the column to edit, then use the
and buttons to set the
desired PCR PID in the stream, then
press the button to save the PID.
Video PID
1. Use the and buttons to move
the cursor to “Video PID :” then press
the button.
2. Use the and buttons to
select the column to edit, then use the
and buttons to set the
desired Video PID in the stream, then
press the button to save the PID.
Video Type
1. Use the and buttons to move
the cursor to “Video Type:” then press
the button.
2. Use the and buttons to
select the video type (“MPEG 2” or
“H.264”) on the PID chosen above,
then press the button.
Note: “H.264’ is only available with the 8732 or 8734 decoders.
Serv Setup ←→
Video PID :0x0000
►Video Type:MPEG 2
Aud 1 PID:0x0000
Serv Setup ←→
PCR PID :0x0010
►Video PID :0x0000
Video Type:------
Serv Setup ←→
Tune Mode:No PSI
►PCR PID :0x0000
Video PID :0x0000
Serv Setup
Aud2 Index:2
Aud3 Index:3
►Aud4 Index:4
To Next Page
Loading...
