Sencore MRD 3187B - Page 161

MRD 3187B - User Manual
Page 160 (245)
Audio 3 Type
3. Use the and buttons to
move the cursor to “Audio3 Typ:”
then press the button.
4. Use the and buttons to
select the audio type (“Dolby AC3”,
“Dolby E”, “MPEG 1”, ”MPEG 2”)
on the PID chosen above, then
press the button.
Audio 4 PID
5. Use the and buttons to
move the cursor to “Aud 4 PID:”
then press the button.
6. Use the and buttons to
select the column to edit, then use
the and buttons to select
the desired Audio PID in the
stream, then press the button
to save the PID.
Audio 4 Type
5. Use the and buttons to
move the cursor to “Audio4 Typ:”
then press the button.
6. Use the and buttons to
select the audio type (“Dolby AC3”,
“Dolby E”, “MPEG 1”, ”MPEG 2”)
on the PID chosen above, then
press the button.
Auto Mode
This mode should only be used if no PID information is known about the stream.
Auto Program
Note: This menu is only available if the “Tune Mode” is set to “Auto”.
1. Use the and buttons to
move the cursor to “Service:” then
press the button.
2. Use the and buttons to
select the desired Service number
in the stream, then press the
button to save the selection.
SDI Audio Embedding
SDI Audio Embedding places decoded or pass through audio in the video horizontal
space in one of 4 available locations. The 8 locations are Group 1 – pair 1 and pair 2,
Group 2 pair 1 and 2, Group 3 pair 1 and 2, and Group 4 pair 1 and 2. To setup the
Serv Setup
Tune Mode: Auto
Service:
►-
Serv Setup
Audio3 Typ:Dolby AC3
Aud 4 PID:0x0028
►Audio4 Typ:DolbyE
Serv Setup ←→
Audio3 Typ:Dolby AC3
►Aud 4 PID:0x0028
Audio4 Typ:Dolby AC3
Serv Setup
Audio2 PID:0x0024
Aud 3 Typ:0x0026
►Audio3 Typ:Dolby AC3